Model Number: RBTX-600P
Wire coil (outer diameter): 300mm (adjustable)
Inner core: 120mm (optional inner diameter)
Wire disc width: 30-100mm (adjustable)
Cable cutting type(1): Drop cable
Cable cutting type(2): butterfly cable
Cable cutting type(3): Self-bearing drop cable
Cable cutting type(4): 12-core optical cable
The speed of the rewire shaft: 0-600 r/min
Cable cutting specifications: 2.0 12.0mm single,double core optical cable.
Main count parameters of the automatic cable cutter
Machine size: length * width * height 2800mm * 1000mm * 1250mm
Operating temperature is 0℃ ~40℃ Power supply: 220~230VAC 50Hz / 60 Hz
Operating temperature is 0℃ ~40℃ Power supply: 220~230VAC 50Hz / 60 Hz
Power supply power: 2.2KW
Condition of storage
The ambient temperature ranges from-10℃ to 50℃ Vibration ranged from 1.0 g 5 to 100 Hz 45min Impact to 5cm free fall
Features of this machine
1.This machine adopts PLC man-machine interface operation, modify the winding length is more convenient.
2.The cable tray is installed and unloaded quickly and conveniently. The combined guide wheel storage line is used, and the linkage brake mechanism is adopted.
3.The wiring adopts PLC and stepper motor automatic wiring, which is easier to operate than the traditional wiring device, side by side line neat and perfect .
4.After the cable into the ring, can use self-expansion type cake head, the inner diameter can be freely loose, can be quickly tied and easily removed, high efficiency, short time.
Scope of application
1.The outer diameter of the wire coil φ300mm (adjustable).
2. Inner core φ120mm (optional inner diameter).
3. The wire disc width is 30-100mm (adjustable).
4. Cable cutting type： leather cable butterfly cable Self-bearing leather line 12-core optical cable.
5. The speed of the rewire shaft is 0-600 r/min.
6. Speed control ：control 2.2KW frequency converter
7. Cable cutting specifications: 2.0 12.0mm single、double core optical cable.
Structure introduction
①optical cable disk
② four-slot guide wheel
③ four-slot guide wheel
④ guide pulley
⑤ Meter pressure wheel
⑥ guide pulley
⑦ send wire wheel
⑧ wiring trough
⑨ slicer
⑩ wiring trough
⑪ single slot guide wheel
⑫ guide wheel
⑬guide wheel
⑭ cable disk take back
Matters needing attention
Common faults and causes of the lower cable machine
Hitch | Cause | Solution |
The cable cutter does not work | Whether the power supply is connected | Connect the power supply |
Whether the length is set to 0 | reset | |
Whether the length is not confirmed | Confirm the length | |
Whether the insurance is in good condition | Replace or install the insurance policy | |
The cable is not in order | Check that the cable is broken | Change |
Check whether the ber matches the cable speed | Adjust the cable-setter speed to match the host cable collecting speed | |
Optical cable on the lower cable machine It will fall or be too loose | Check the springs on the cable shelf | Adjust the spring tightness appropriately |
Contact Us
GET IN TOUCH AND REQUEST A QUOTE
